The actual model and manufacturer are only used to help you identify the correct bat in the app, those values are not used for any of the calculations and are only included to help you identify the correct bat from a list of your own created bats. As long as the proper weight and length are entered you will be good to go! Length and weight will be used for the calculations.
To add a bat, go to the Settings page. In the Settings page, click into the Sensors tab. Once your Bat Sensor is paired, click on the green "i" button. From there, it will take you to the Sensor Information page where you can add/change your bat(s).
Troubleshoot tip:
If you are unable to select a bat or you receive an error that it is failed to assign a bat, please follow these steps:
Please close out of the app and then we would like you to reset your Bluetooth! Please follow the steps below:
1. Go into your Settings app on your Apple Device
2. Select "Bluetooth"
3. The switch at the top will show green. Click the switch so it shows grey
4. Wait 15 seconds
5. Select the switch again so that it shows green
After this go back into the app and try adding a bat again!